I just replaced my double insulated pump that came with the Doughboy pool. It was never bonded to the pool and as far as I can tell from reading the information here is that it was not necessary.
I have recently replaced the old pump with a new 1hp Hayward Power-Flo Matrix and am definitely going to bond it to my 24' ABG Doughboy. My question is?? Is it necessary to totally encircle the pool and attaching at 4 equal point of the pool or is it ok to bond using only one connection to a pool upright support and how important is it to water bond it also?
And should I also drive a 8' copper rod and ground it there too? I'm sure this has been addressed before on the site so please forgive me,
Thank You in advance!
I have recently replaced the old pump with a new 1hp Hayward Power-Flo Matrix and am definitely going to bond it to my 24' ABG Doughboy. My question is?? Is it necessary to totally encircle the pool and attaching at 4 equal point of the pool or is it ok to bond using only one connection to a pool upright support and how important is it to water bond it also?
And should I also drive a 8' copper rod and ground it there too? I'm sure this has been addressed before on the site so please forgive me,
Thank You in advance!