Hey all, in short I had a post on here a couple months back where my under cover pump died, used siphon hoses to drain while ordering a new pump, forgot to remove one siphon hose, drained half of pool in the process since cover was on and I didnt see it, heavy rains then floated my liner, bad mess. Pool is full again now, liner sat back in place, and they are opening it today. Its a 28,000 gal inground SWG. It was drained to the point of about 2 inches deep in the shallow end, then filled back up with fresh water. So I know my water is in major need of everything.
Just wondering what I should do first. Test all levels then add everything needed at once? Shock first? Add salt? I know the salt and chlorine levels will be way off, probably everything with be. I do have a drop test kit recommended by everyone here. I have been reading pool school, just want to go through the right steps since I had a rough winter with this thing.
Is there a good way to test the salt levels, other than taking to pool store? Or just turn on the SWG and let it tell me?
Thanks
Just wondering what I should do first. Test all levels then add everything needed at once? Shock first? Add salt? I know the salt and chlorine levels will be way off, probably everything with be. I do have a drop test kit recommended by everyone here. I have been reading pool school, just want to go through the right steps since I had a rough winter with this thing.
Is there a good way to test the salt levels, other than taking to pool store? Or just turn on the SWG and let it tell me?
Thanks