Stenner Pump Rebuild

Jump to latest Follow Reply
M

mtnracer190

0
Jan 16, 2013
2
Im trying to revive a stenner pump that I bought for a few dollars. Everything is in tip top shape on it except for the mounting rivets on the feed rate head. Does anyone know how broken ones can be removed? I have included some pictures so that you will know exactly what I am talking about. As you can see from the picture I was able to get one of them out but not the other two.

Thanks in advance!
P1020145.jpg


P1020146.jpg
 
I'd say that you're going to have to drill them out. If you know someone with a drill press, it will make it easier. However if those holes go all the way through, you can just drive them out with a drift or small bolt.
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply