Hi All
I am quite frustrated at this stage
running the pool normally with out the "kreepy" - there are some bubles at the inlet jets- but the suction is good
If I connect my "kreepy" it cleans for about 5 -10 seconds and then the pump start to labour
I have already replaced the following in order:
1 - sand - and seal on top of sandfilter -
2 - Selector switch and station
3 - the cover in pool weir
4 - tested the kreepy pipes - no leaks - also checked the diafram on the "kreepy" replaced with new one
5 - replaced the cover for the filter just infront of the pool pump
none of the above has helped
The pool is not loosing any water -
what do you suggest I check next - pump or the pipes that runs from the weir to the pump
any help please!!
I am quite frustrated at this stage
running the pool normally with out the "kreepy" - there are some bubles at the inlet jets- but the suction is good
If I connect my "kreepy" it cleans for about 5 -10 seconds and then the pump start to labour
I have already replaced the following in order:
1 - sand - and seal on top of sandfilter -
2 - Selector switch and station
3 - the cover in pool weir
4 - tested the kreepy pipes - no leaks - also checked the diafram on the "kreepy" replaced with new one
5 - replaced the cover for the filter just infront of the pool pump
none of the above has helped
The pool is not loosing any water -
what do you suggest I check next - pump or the pipes that runs from the weir to the pump
any help please!!