jtb33 said:
Any updates on how the non-OEM SWG's are doing?
I received mytitanium cell from poolexpress and installed around end of July - worked right away, I had been adding liquid chlorine until then.
Until recently, all was fine. Now not generating - flow is fine, realized it when green algae appeared. Called Friday (yesterday) tech support of pool express (left my number on voicemail, didn't get call back within 30 min so called again). Went thru diagnostic button codes with tech and he told me I wasn't getting enough power to the unit. Said could be K1 relay or check for burn marks on board. Said to go to nocellpower.com and instructions will be there. Had to go to work so did last night.
Seems the site is more for those with no power. With mine, is just not generating (generating light will not go on, whether by % or superchlor). Opened and inspected board and I see NO burn areas. K1 is a rectangular box which looks ok.
Tried calling poolexpress (Aqualine / Jandy is only open only M-F). This time a person told me I would get a call back in a few minutes. Again, 45 min later called back, told me tech support may not be open on Sat - it's an answer service).
So, these are my readings:
3500
85
0.6
0.00
91P
- 0
Al-5
r 1.40
Is it the 0.6 that is low volts (or amps) that is the problem?
I understand the salt reading is an average so not accurate. I used a salt tester today that reads about 3200 - I was hoping maybe a high salt was stopping it from generating, but that's not too high. I'm wondering if the 3500 it displays could be stopping it from generating, although I don't think that's excessively high either.
either way, was warned the circuit board might go in a short time after cell replacement (any brand), so just reporting back for others and in case any suggestions are available.
Most of the forums discuss the replacement of the current limiter showing a quarter sized piece that I did order from digikey (when I ordered the new cell) but don't see the same piece on my circuit board. Any suggestions? Otherwise waiting for tech call on Monday. My circuit board says Jandy Aquaswitch Assy#7200.
Steven