Become a TFP Supporter Pool Math Forum Rules Pool School
Results 1 to 2 of 2

Thread: Pentair CVA24T Valve Actuator Wiring Diagram

  1. Back To Top    #1
    tomzo's Avatar
    Join Date
    May 2011
    Escondido, CA

    Pentair CVA24T Valve Actuator Wiring Diagram


    I am looking to use a relay to add a third valve actuator to my Easytouch 4 Single Body controller and was wondering if anyone had access to a wiring diagram for the Pentair CVA24T valve actuator. I want to know what each of the three wires does so I can design a proper relay circuit to control it.


    21K Gal Vinyl In Ground with block wall sides (Self Built with help), Pentair Easy Touch controller, Pentair Intelliflo pump, Intellichlor salt system, Clean and Clear Plus filter, SR Smith Typhoon Slide

  2. Back To Top    #2
    JasonLion's Avatar
    Join Date
    May 2007
    Silver Spring, MD

    Re: Pentair CVA24T Valve Actuator Wiring Diagram

    There is a little bit more to an actuator controller than just a relay. See for example the Jandy 5254 JVA Auxiliary Relay Board, which has the circuit required to control an actuator from a relay.
    19K gal, vinyl, 1/2 HP WhisperFlo pump, 200 sqft cartridge filter, AutoPilot Digital SWG, Dolphin Dynamic cleaning robot
    Creator of PoolMath and Pool Calculator. Other handy links: Support this site, TF Test Kits, Pool School

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts