This is the second year of use for our Krystal Clear Sand and Salt Water System 1600gph for our 16ft diameter Intex pool. Last year everything ran perfectly. After only having the system hooked up for a couple of weeks this year we are having nothing but problems. we stored it properly, to the T, duing the winter! We keep getting a low salt alarm. At first I just added a little salt, then, when we got the alarm again in just a day or two, I knew something was up. Checked the manual said to clean the electrolytic cell, did that, but still getting low salt alarm. Intex hasn't been much help. Say I need to replace the cell but it seems fine. I can tell chlorine is being made by all the bubbles forming on the plates when the unit is running. Our unit is no longer under warranty and really can't afford to get another right now. Was wondering if there is a way to bypass the low slat alarm and just monitor the salt levels myself so that it will keep making chlorine? Right now I am having to turn on the unit, let it run till it shuts itself off because of the alarm, which is just 1 hr, then start over again.