Hi All,
We just finished up a complete remodel of our pool built in 2001. The PB demo'ed the concrete deck, tile, coping, etc and installed all new plumbing, pavers, pebblesheen, tile, deck, pebblesheen, etc.
The skimmers were not replaced because the PB said removing them would affect the structural integrity of the pool.
So, I filled the pool to about 1.5 inches above the bottom of the tile and the water level is too high for the skimmer. Dirt/debris is just floating right by. Am hoping that you all will have a suggestion that will solve this issue. I could lower the water level, but it doesn't leave much room before exposing Pebblesheen. Thanks in advance for the replies!
We just finished up a complete remodel of our pool built in 2001. The PB demo'ed the concrete deck, tile, coping, etc and installed all new plumbing, pavers, pebblesheen, tile, deck, pebblesheen, etc.
The skimmers were not replaced because the PB said removing them would affect the structural integrity of the pool.
So, I filled the pool to about 1.5 inches above the bottom of the tile and the water level is too high for the skimmer. Dirt/debris is just floating right by. Am hoping that you all will have a suggestion that will solve this issue. I could lower the water level, but it doesn't leave much room before exposing Pebblesheen. Thanks in advance for the replies!