- Aug 16, 2010
- 31
My last cell and cord became burnt/rusted so I replaced them both. After installing the replacements and going into the "installer menu" to "replace cell" the digital display says that the purifier is "off" and it's set to 1%. I cannot raise it by pressing the "up" arrow. Why? I can place it into Boost mode but I'm not sure if that actually does anything if the purifier is set to 1%.
FWIW, I know the "up" arrow button works just fine since I can use it to navigate the menus.
When I run the test mode the Pool Pilot displays: SC-36, cell power 2, 3000 ppm salt, 18v 6.4A, 55 degrees F.
Thanks for any help,
Phil
FWIW, I know the "up" arrow button works just fine since I can use it to navigate the menus.
When I run the test mode the Pool Pilot displays: SC-36, cell power 2, 3000 ppm salt, 18v 6.4A, 55 degrees F.
Thanks for any help,
Phil