Would like to know if any one knows how to interface the Jandy RS 8 to a Hayward ecostar pump?
Interface Hayward ecostar and jandy controller
- Thread starter nats1956
- Start date
That's going to require a main board and firmware upgrades. And even then, I am not certain it can talk to a Hayward VSP. A Pentair or Jandy's own, yest but I don't know.
Scott
Scott
- May 3, 2007
- 16,839
- Pool Size
- 20000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
This may not be what you are looking for but you could just connect the EcoStar as you would a single speed pump via a relay and then use the EcoStar internal timers to control the speeds at different run times. If you want full control of the EcoStar speeds from the Jandy controller, I think that is going to be a problem.
Similar threads
