Aqua Logic controller issue

[Timbo99]

I have an Aqua Logic PS-8 controller. The pump comes on at the programmed time but no other commands work (such as service mode, lights, etc). Even when the pump is off I cannot mannually get it to turn on by pressing 'Filter' button on the controller. Also. the 'check system' LED is on and the readout says to inspect cell. I cleaned the salt cell and it wont reset the error when holding the + button for 3 seconds. Anyone have any ideas on these problems? Thanks!

 

[PoolGuyNJ]

Sounds like a fried control panel. Do you have a remote?

Scott

 

[Timbo99]

Scott, thanks for the reply. I have a wired remote in the master bedroom. I have no control from that remote either. I would assume its probably the main GLX circuit board that needs repair/replacement. I found a guy on E-bay that repairs the PCB for less than $200 with a 90 day warranty. Any feedback would be appreciated.
Tim