How does IntelliBrite 5G connect to EasyTouch?

[slavka001]

I am reading manuals but yet to find one how the lights are connected to the Easy touch. I am suspecting lights are connecting to the AUX relays.
True?
if I have two lights, do I parallel them or connect to different AUX relays?
Help would be appreciated. I am taking care of all the electrical connections and that one is so far a mistery to me.

 

[PoolGuyNJ]

Just tell the EZT that the aux is an Intellibrite. If you have two in the pool, I would put them both on the same relay. If you have a spa, I would put it on a separate relay if you have the space.

Scott

 

[slavka001]

Just tell the EZT that the aux is an Intellibrite. If you have two in the pool, I would put them both on the same relay. If you have a spa, I would put it on a separate relay if you have the space.

Scott

Great!!! Thank you.
I will just power them from the same AUX relay. I could not believe pentair did not have a single instruction in EZT or Intellibrite manual.

 

[satx66]

when setting them up on the EZT, make sure you go into the lights menu >config and enter the lights there (as well as the 'Intellibrites' in the settings menu).... mine weren't syncing until I did that

 

[Dan-H]

when setting them up on the EZT, make sure you go into the lights menu >config and enter the lights there (as well as the 'Intellibrites' in the settings menu).... mine weren't syncing until I did that

same thing with any lights. without doing this all lights on/off don't work...