- Sep 11, 2011
- 1
Installed a brand new aquarite pcb but unit still does not generate. Registers 0 for salt, nothing for instant salinity. When turned on will have flow light blinking, then goes to power light green and generating green for a few seconds. Then it gets a steady red light on LOW SALT and a steady yellow light on CHECK CELL. Cell has been checked and is good at local pool store and it is clean. Have reset the unit a million times. Pool store said it could take 24 hours for it to start reading and working. But a week later and still not working.
Salt level tested at 3600 ppm. Alkalinity is a little high at 170ppm, ph is good at 7.4
I am beginning to wonder if we got a new bad board.
Salt level tested at 3600 ppm. Alkalinity is a little high at 170ppm, ph is good at 7.4
I am beginning to wonder if we got a new bad board.