- Jun 28, 2011
- 3
So...I think I've tried everything. New cell, new cord, new fuses, cleaned sensor, etc,.
On power up, 13 volts/2.4 amps, a couple minutes later, 4 volts/.4 amps, a couple minutes later, 0 volts/.2 amps.
From what I'm reading...the power supply is dead? Is that the correct conclusion before I order a new power module...which I believe is part # 16084.
Is it common for these to poop out in 6 years, as that's the age of my current system.
Appreciate everyone's comments on this board, although I think I've exhausted my options.
I've seen the 16084 online for $400.00...is that about as good as it gets?
Thanks!
Jeff
On power up, 13 volts/2.4 amps, a couple minutes later, 4 volts/.4 amps, a couple minutes later, 0 volts/.2 amps.
From what I'm reading...the power supply is dead? Is that the correct conclusion before I order a new power module...which I believe is part # 16084.
Is it common for these to poop out in 6 years, as that's the age of my current system.
Appreciate everyone's comments on this board, although I think I've exhausted my options.
I've seen the 16084 online for $400.00...is that about as good as it gets?
Thanks!
Jeff