Realized last week that output of my Zodiak LM2 was quite limited because two chunks of the cell where missing when viewed from the bottom. Cheapest replacement I could find was about 350. Figured 450 for a whole new compupool would be worth it.
Swap was pretty straight forward wiring was simple swap, and the cell spacing was the same. Just cut off the old fittings, glued on 1 /12 to 2" converter which fits the outer part of the new fittings.
Great to actually see huge amount of gas pouring out of the thing. I noticed that the incremental LCD output lights have a lag with respect to selected output settings. Yesterday the unit was at 100% for a while and producing nicely. I set the unit down to 70%. Today, FC was down to 3 and I'd like it around 4.
So I noticed the output lcd only had one bar. Even when I adjust the output to 100%, I only get one bar. Ideas?
Swap was pretty straight forward wiring was simple swap, and the cell spacing was the same. Just cut off the old fittings, glued on 1 /12 to 2" converter which fits the outer part of the new fittings.
Great to actually see huge amount of gas pouring out of the thing. I noticed that the incremental LCD output lights have a lag with respect to selected output settings. Yesterday the unit was at 100% for a while and producing nicely. I set the unit down to 70%. Today, FC was down to 3 and I'd like it around 4.
So I noticed the output lcd only had one bar. Even when I adjust the output to 100%, I only get one bar. Ideas?