i want to take my pool light housing out so i could do a niche dye test to see if there is any leak there. after reading here it seems like there should be a single screw that would hold an outer ring of the light that keeps the housing in place.
looking at the picture of my light, i see one screw that is visible thru the opening in the ring on top and one missing screw on the bottom. but it doesn't look like if i remove the top screw that the ring would come off.
there are 4 round holes in the ring and then there are 10 screws that seem to keep the ring affixed to the liner.
so looking at all this, i'm somewhat confused how i should remove the housing. the light is made by Hayward, but i don't know specific model. i could take a better look this weekend when i get in the water. this was a shot taken from outside holding my camera in the water. at least i can say that my water is clean
looking at the picture of my light, i see one screw that is visible thru the opening in the ring on top and one missing screw on the bottom. but it doesn't look like if i remove the top screw that the ring would come off.
there are 4 round holes in the ring and then there are 10 screws that seem to keep the ring affixed to the liner.
so looking at all this, i'm somewhat confused how i should remove the housing. the light is made by Hayward, but i don't know specific model. i could take a better look this weekend when i get in the water. this was a shot taken from outside holding my camera in the water. at least i can say that my water is clean