OK - I have tried to do my homework prior to this posting... this forum has taught me so much over the years, I'm going to the well once again...
I have an Autopilot SC-36 that is 5 yrs old, after receiving numerous "Check/Clean Cell" messages late last year, I decided to replace the Salt Cell & Cable for the pool opening this Spring.
Fast forward to this Spring, I just finished replacing the SC-36 Salt Cell & Cable in the pool system, and was sure to use the REPLACE CELL command to reset the cell counter on the AutoPilot - but I am still getting an error "Check/Clean Cell" message. I have checked cables, connections, etc everything looks good...
Autopilot Test:
Power Level 2
16 V, 4.3 A
Current pool readings are:
FC 0.5 ppm
TC 0.7 ppm
CC 0.2 ppm
pH 7.9
Hardness 230 ppm
Alk. 86 ppm
CYA 15 ppm
Salt 2600 ppm
I am raising the CYA tonight, as well as Alkalinity - so I am confident I can get those numbers perfect by week's end...
Any advice on what the "Check/Clean Cell" message could mean in this situation...?? Any help would be so appreciated.
-- Mitchman
I have an Autopilot SC-36 that is 5 yrs old, after receiving numerous "Check/Clean Cell" messages late last year, I decided to replace the Salt Cell & Cable for the pool opening this Spring.
Fast forward to this Spring, I just finished replacing the SC-36 Salt Cell & Cable in the pool system, and was sure to use the REPLACE CELL command to reset the cell counter on the AutoPilot - but I am still getting an error "Check/Clean Cell" message. I have checked cables, connections, etc everything looks good...
Autopilot Test:
Power Level 2
16 V, 4.3 A
Current pool readings are:
FC 0.5 ppm
TC 0.7 ppm
CC 0.2 ppm
pH 7.9
Hardness 230 ppm
Alk. 86 ppm
CYA 15 ppm
Salt 2600 ppm
I am raising the CYA tonight, as well as Alkalinity - so I am confident I can get those numbers perfect by week's end...
Any advice on what the "Check/Clean Cell" message could mean in this situation...?? Any help would be so appreciated.
-- Mitchman