Installing a 20' sharkline Matrix.
Spent several days digging and measuring with 11' 2X6 with 4' level on top - everything looked good.
THen on to the patio stones, dug each one out and checked level with the 2x6 and than checked level against the patio stone on each side, then went all around with the 2x6 and checked it all out before stopping. Did alot of fine tuning and everything looked good.
Put bottom rails together, measured until round.
Put the wall up - remeasured until round.
Put liner up, got it all nice, then put the top caps on and starting filling.
Now, there's a couple inches in there and I decided to take the measuring tape and go around the outside edge to check the measurement.....and it's out by a couple inches.
Someone PLEASE tell me this is normal, will this thing become more round as it fills?? (I feel stupid asking that) but all my measurements seemed good, and I quadruple checked them.
Spent several days digging and measuring with 11' 2X6 with 4' level on top - everything looked good.
THen on to the patio stones, dug each one out and checked level with the 2x6 and than checked level against the patio stone on each side, then went all around with the 2x6 and checked it all out before stopping. Did alot of fine tuning and everything looked good.
Put bottom rails together, measured until round.
Put the wall up - remeasured until round.
Put liner up, got it all nice, then put the top caps on and starting filling.
Now, there's a couple inches in there and I decided to take the measuring tape and go around the outside edge to check the measurement.....and it's out by a couple inches.
Someone PLEASE tell me this is normal, will this thing become more round as it fills?? (I feel stupid asking that) but all my measurements seemed good, and I quadruple checked them.