I just installed a new chlorinator, a Hayward TurboCell (T-15), when trying to install it, I am supposed to configure my AquaLogic PS-4. When attempting to do this, the AquaLogic won't show "Chlor. Config" under the Configuration Menu. Any ideas?
Chlorinator Help
- Thread starter GamecockFan01
- Start date
Welcome to TFP!
Have you run the four wire communications cable between the AquaLogic and the AquaRite units?
Have you run the four wire communications cable between the AquaLogic and the AquaRite units?
The T-15 unit came with one cord and I plugged it in to the AquaLogic unit. That was the only cord that came with the unit.
Sorry, my previous comments are for a different setup where there is a separate SWG control box.
There should be cell (the T-15) and a separate flow switch module, with two separate cables going back to the automation system. It won't work without the flow switch, which is a separate piece that installs in the plumbing close to but separately from the cell.
There should be cell (the T-15) and a separate flow switch module, with two separate cables going back to the automation system. It won't work without the flow switch, which is a separate piece that installs in the plumbing close to but separately from the cell.
Similar threads
