Digital nano

[mlaaw]

Just installed the nano yesterday. I have the 220V version and wired it to my pumps timer so the nano comes on and off when the pump starts and stops. My question is when it powers on it starts at 50% output, how am I susspose to fine tune it when it starts everyday at 50%? The book says "At start up of a new system, the standard output setting starting point is 50%." Does anyone have any knowledge of pool pilot SWG's?

 

[Poolsean]

I may have a little knowledge on Pool Pilot swg's. Did you press the arrow up or down to change the output %?

 

[mlaaw]

Yes that was it. It starts at 50% then i guess it was lowering due to the temperature and when it would restart it went back to 50%. Now that I have changed it manually it starts where i had the setpoint before.