Jandy LT Heater - Ignition Problem

[SnowAviation]

Today the Heater stopped working with an AGS code.

Gas pressure is OK, verified.

I measured 59 ohms on the ignitor when disconnected from the system

I measured 240 volts to the board between the controller and the ignitor
I measured 43 volts to the ignitor when the system is on.
I measured 59 volts to the ignitor when the system is trying to ignite.

Ignitor does not glow.

Gas valve is operating normally.

Any Ideas?

 

[PoolGuyNJ]

Igniter is shot I think. The resistance, IIRC should be about 8 ohm.

Scott