- Aug 28, 2010
- 32
Hi
Newbie here!
I have a goldline pro logic Pl-P4 and up until this morning it was showing 2,800ppm for salt. This dropped to 2,500 and came up with check system message to add salt which I did, the reading then shot up to 3,800 (no big deal)
But when I went to get the water tested it showed 2,500 on all tests!
Ok here is the question - I went into diagnostic menu for the cell and it showed "instant salt as 2,500" ha ok its asking me to press save which i did. I returned to the default screen and the salt value has changed to 2,500 and asking for salt!
UG back to square one, so I add more salt the "instant salt reading stabilises at 2,900" I press save again and the default display now shows 2,900!
Any ideas whats going on? It seems by pressing enter in the diagnostic menu its setting up some fixed value in the default screen for the instant value which is effecting the service light asking for more salt.
So do i go by the active salt value? and where did the average salt value go to?
Newbie here!
I have a goldline pro logic Pl-P4 and up until this morning it was showing 2,800ppm for salt. This dropped to 2,500 and came up with check system message to add salt which I did, the reading then shot up to 3,800 (no big deal)
But when I went to get the water tested it showed 2,500 on all tests!
Ok here is the question - I went into diagnostic menu for the cell and it showed "instant salt as 2,500" ha ok its asking me to press save which i did. I returned to the default screen and the salt value has changed to 2,500 and asking for salt!
UG back to square one, so I add more salt the "instant salt reading stabilises at 2,900" I press save again and the default display now shows 2,900!
Any ideas whats going on? It seems by pressing enter in the diagnostic menu its setting up some fixed value in the default screen for the instant value which is effecting the service light asking for more salt.
So do i go by the active salt value? and where did the average salt value go to?