When I power on my aqua comfort heater i receive a flashing "Po" error code.
The manual states this error means open connection on water temperature sensor or bad sensor.
I opened up the unit and examined the sensor and the cable leading up to the control panel. It looked clean and not cut. Cleanly connected to terminal.
Is a professional necessary to correct this issue or should i try to get a replacement sensor from the manufacturer and install myself?
Does anyone have experience with this type of heater?
The manual states this error means open connection on water temperature sensor or bad sensor.
I opened up the unit and examined the sensor and the cable leading up to the control panel. It looked clean and not cut. Cleanly connected to terminal.
Is a professional necessary to correct this issue or should i try to get a replacement sensor from the manufacturer and install myself?
Does anyone have experience with this type of heater?