So I was all gung ho this season, got the water CRYSTAL clear thanks to TFP. Then I found out that my SWG wasn't working. I've been back and forth with Polaris, and they sent me a new cell (as in previous years I've already replaced the control panel and the entire control module).
So it was backordered, and I waited about two weeks for it, all the while spending money on bleach. I finally got it yesterday and installed it.
Guess what: the control screen freezes after 1-2 minutes of operation.
There is a GFCI that when tripped turns off the autoclear - that's the only other thing I can think of that would cause this.
*The error code 94 indicates a "cut cell" cord - the control module can't see the cell. When the screen is not frozen, it alternates between this error code 94 and normal operation.
I am at my wits' end. Does anyone have any ideas?
So it was backordered, and I waited about two weeks for it, all the while spending money on bleach. I finally got it yesterday and installed it.
Guess what: the control screen freezes after 1-2 minutes of operation.
There is a GFCI that when tripped turns off the autoclear - that's the only other thing I can think of that would cause this.
*The error code 94 indicates a "cut cell" cord - the control module can't see the cell. When the screen is not frozen, it alternates between this error code 94 and normal operation.
I am at my wits' end. Does anyone have any ideas?