So apparently I did a really stupid thing and decided to fiddle with my pump speeds. I haven't touched anything since the PB set it all and after reading the Pentair website today, I decided I wanted to try lowering my Intelliflo VSP. The prior configurations had the pool set to a speed of 2350, cleaner 2500, Spa 3000 and Air Blower 3300. Those were the only 4 set pump circuits. I have a fountain in the spa that leads to a spillway into the pool---that's my only water feature. I turned the pump down to 1800 and everything shut off and the red "no flow" light on the Intellichlor went on and status said "blocked". I bumped it up to 2000 and it kicked on but when the fountain started ramping up (it always dials up and then comes back down to the pre-set location) it all shut off again and the red light came back on. I freaked out and put everything back to where the PB had it. Started it back up and everything seems fine EXCEPT now the return jets have air bubbles and gurgling sounds coming out of them. Good Lord WHAT HAVE I DONE!??!!? Aside from turning everything off and pouring myself a glass of wine, I don't know what to do now!
Can I not run my pump at a lower speed with this water feature? Why do I now have air bubbles and gurgling in my return jets? Seriously....I need more wine. HELP!!! :shaking:
Can I not run my pump at a lower speed with this water feature? Why do I now have air bubbles and gurgling in my return jets? Seriously....I need more wine. HELP!!! :shaking: