I've read lots of posts on this topic and am still confused.
I have an above ground resin pool that I ran a #8 bare copper cable off of a lug I attached to the seam bolts on the wall. I also have the pool pump and a saltwater control/timer (Aquatrol) to tie in (bond).
The aquatrol directions mention connecting everything in a "bonding loop", but is it really a loop or do I just need to connect everything in series?
Right now I have 20' wire just attached to the pool wall lug and not sure how to connect the other two pieces of equipment. Both have bonding lugs on them so that part is not too difficult the "loop" part has me thrown as does the issue of whether "connections" are allowed to tie three pieces together.
An electrician did my pool power, but not the bonding loop (pool wasn't done).
Thanks.
I have an above ground resin pool that I ran a #8 bare copper cable off of a lug I attached to the seam bolts on the wall. I also have the pool pump and a saltwater control/timer (Aquatrol) to tie in (bond).
The aquatrol directions mention connecting everything in a "bonding loop", but is it really a loop or do I just need to connect everything in series?
Right now I have 20' wire just attached to the pool wall lug and not sure how to connect the other two pieces of equipment. Both have bonding lugs on them so that part is not too difficult the "loop" part has me thrown as does the issue of whether "connections" are allowed to tie three pieces together.
An electrician did my pool power, but not the bonding loop (pool wasn't done).
Thanks.