Hi to all
My Aquarite is now in its 5th year of use. It is on its 2nd computer board and 2nd fuel cell. The fuel cell was replaced over the summer after it kept reading very low for the salt - and putting in a new one fixed it.
Just came back from a trip and the pool is green. Apparently there is no chlorine.
The "no flow" light comes on then goes off. The generator life goes on for 30 seconds and goes off and then there are no lights at all.
The amps are reading 0 and the voltage is low at 14.4.
I have read online from others who have had this and they have replaced the board. But before I go and buy one I want to see if anyone else has had this problem.
We tested the fuse and it is fine. We also tested the flow sensor with a phone line and it is not that. The thermistor does not look cooked. The board is just about 1.5 years old - it was replaced in the summer of 2008 and it was under warranty.
If you have any advice or experience please help.
I
My Aquarite is now in its 5th year of use. It is on its 2nd computer board and 2nd fuel cell. The fuel cell was replaced over the summer after it kept reading very low for the salt - and putting in a new one fixed it.
Just came back from a trip and the pool is green. Apparently there is no chlorine.
The "no flow" light comes on then goes off. The generator life goes on for 30 seconds and goes off and then there are no lights at all.
The amps are reading 0 and the voltage is low at 14.4.
I have read online from others who have had this and they have replaced the board. But before I go and buy one I want to see if anyone else has had this problem.
We tested the fuse and it is fine. We also tested the flow sensor with a phone line and it is not that. The thermistor does not look cooked. The board is just about 1.5 years old - it was replaced in the summer of 2008 and it was under warranty.
If you have any advice or experience please help.
I