I just installed the aquarite aqr-x296 arid climate T-3 15k gallon salt system and the salt level on my pool is 3300ppm as it was checked yesterday. I did the initial setup prior to connecting the cell to the t-3. I have software version 1.5. When i first turned it on with the cell connected The reading was 1800 and I was getting errors. I turned it off and back on and it went to 2600 but I get the inspect cell and the check salt lights flashing. It says generating now but not before.
I know with autopilot you can calibrate the salt level but I could not find anything in the useless included manual about calibrating the salt initially.
I know with autopilot you can calibrate the salt level but I could not find anything in the useless included manual about calibrating the salt initially.