Replacing pool pump only.

[Byrd3790]

I have an emerson motor seen here

Motor

With a Hayward pump, the part with the viewing window and basket. Unfortunately the pump section has no serial or model number. It has a place for one but it is blank seen here

Pump Plate

The intake on the pump section is cracked
and I am hoping to replace it without having to replace the motor since the motor works just fine.
Here is the pump itself.

Pump

Is this possible? if not do you have any suggestions for a new unit that's not terribly expensive?

 

[mas985]

That is a Hayward SuperPump. More than likely it is the 1 HP.

Is the pump housing cracked or is it the fitting that goes into the housing?

 

[Byrd3790]

It is the section of housing around the fitting. I have put some pipe repair epoxy around it which has helped but I would like to replace it.

 

[mas985]

This may not be the cheapest but it gives you the part number: Hayward Super Pump Housing SPX1620AA. Hayward SPX1620AA.

IF you have 1 1/2" plumbing, then this one: Amazon.com: Hayward SPX1600AA Pump and Strainer Housing Replacement for Hayward Super Series Inground Pumps: Patio, Lawn Garden

 

[Byrd3790]

Yes it's 1 1/2 thank you so very much

 

[Hayward Pool]

I have decided that once in a while I will send out a part. If this guy private messages his address I will provide a new housing.

 

[Byrd3790]

That would be amazing. PM has been sent.