I just had an easytouch and screenlogic system installed with a new heater and to be fair the install of the heater is not complete yet. I was expecting this to be as easy as programming my harmony remote. graphical interface with drag and drop. I am trying to program it because i dont want my pool to go green while they finish up. So here goes the questions:
Can the swg be independently controlled from the pump?
If i have the pump set on low and no waterfall and my wife wants to turn it up and put on the waterfall can this be treated as an egg timer and then go back to the program?
The servo on the waterfall valve is new but the way it is setup it goes through a close mode on the pump out let basically shutting the pump down. i dont think this is a control issue but a physical set up issue.
Can the swg be independently controlled from the pump?
If i have the pump set on low and no waterfall and my wife wants to turn it up and put on the waterfall can this be treated as an egg timer and then go back to the program?
The servo on the waterfall valve is new but the way it is setup it goes through a close mode on the pump out let basically shutting the pump down. i dont think this is a control issue but a physical set up issue.