Pressure test???

[Kfkruse]

I'm am plumbing a pool and I need to know how to pressure test my fittings. Can someone give me some guidance??


Sent from my iPhone using Tapatalk

 

[cowboycasey]

from what I have seen you just cap the ends and one end use a union connected to a pressure gauge and take everything to I think 25 PSI.. I have seen someone post a kit before that they used...

here is a setup from a company

 

[Kfkruse]

from what I have seen you just cap the ends and one end use a union connected to a pressure gauge and take everything to I think 25 PSI.. I have seen someone post a kit before that they used...

here is a setup from a company

So I used a tubeless stem in a cap and sealed off other ends. Pumped with air from compressor and brought it to 20 lbs. (checked with tire gauge). Checked about an hour later still at 20 lbs. a coupling is cheap compared to some of the stuff needed in that video. I have a 2" and a 1 1/2 that's on a male threaded for my jets. Problem solved



Sent from my iPhone using Tapatalk

 

[Kfkruse]

from what I have seen you just cap the ends and one end use a union connected to a pressure gauge and take everything to I think 25 PSI.. I have seen someone post a kit before that they used...

here is a setup from a company

But I thank you very much for your helpful input. Love this board!!!


Sent from my iPhone using Tapatalk

 

[cowboycasey]

I really like your way, nice and easy