My Jandy Aquapure started beeping and produced an error code of 170. I consluted the manual troubleshooting guide here: http://www.pleasurepoolsno.com/wp-content/themes/pleasurepool_latest/pdf/AquaPure%20and%20PureLink%20Troubleshooting%20Manual.pdf
I tested the Transformer voltage (Pins 1-8) which read 79 - should be 75
Pins 2-7 read 69 - should be 65
Pins 3-6 read 21 - should be 21
Pins 4-5 read 0 since cell will not turn on
Front board test with sensor disconnected
Expected 2.8 - actual 2.8
Expected 75 - actual 74
Expected 91- actual 90
I am trying to figure out if these reading mean the transform is bad (not within range) as well as the front board (not within range either) or if a bad transformer is leading to the bad readings on the front board?
Anyone have any advice on this situation?
Thanks!
I tested the Transformer voltage (Pins 1-8) which read 79 - should be 75
Pins 2-7 read 69 - should be 65
Pins 3-6 read 21 - should be 21
Pins 4-5 read 0 since cell will not turn on
Front board test with sensor disconnected
Expected 2.8 - actual 2.8
Expected 75 - actual 74
Expected 91- actual 90
I am trying to figure out if these reading mean the transform is bad (not within range) as well as the front board (not within range either) or if a bad transformer is leading to the bad readings on the front board?
Anyone have any advice on this situation?
Thanks!