Hello to All,
I initiated the heater icon on the remote, the icon came on, but after 5-10 min, I noticed the temp has not increased. I went to equip pad and turned off the heater at the control panel. I turned it on again at the c-panel, but nothing happened, so I turned off again, It was in spa mode the whole time.
The heater had the yellow light lit on "stand-by" and a code of "bo". I looked this up in the Hayward H400FD manual and nothing was listed as an error code, if it is one at all. We did have a rain storm last night, and I have heard that these devices are not the best water proofed. Could it be a water issue?
Finally, Hayward replaced the motor on the VSP 3 days ago and the tech, that was really good', did some program grouping for me. I also had an actuator valve that was installed incorrectly by the PB for the filter-bypass, so he corrected that. He grouped the filter bypass [valve-3], the heater and spa all together. I was going to run the spa, heater and blower together bc I do so to circulate water this way, and run the heater periodically for maintenance purposes. After putting in spa mode and starting the heater from the remote, I meant to hit the blower, but I hit the filter-bypass [valve-3] and when I re-hit the filter bypass to turn it off, it turned off both the spa and heater. Could this have had an impact.
As a follow-up, I just went out again to the c-panel and went from pool to spa mode, then turned on the heater again and after 15 sec's, it did not fire-up like it usually does in 3-4 seconds.
Is there anything I can do to troubleshoot this or does anyone have any recommendations?
thanks,
tstex
I initiated the heater icon on the remote, the icon came on, but after 5-10 min, I noticed the temp has not increased. I went to equip pad and turned off the heater at the control panel. I turned it on again at the c-panel, but nothing happened, so I turned off again, It was in spa mode the whole time.
The heater had the yellow light lit on "stand-by" and a code of "bo". I looked this up in the Hayward H400FD manual and nothing was listed as an error code, if it is one at all. We did have a rain storm last night, and I have heard that these devices are not the best water proofed. Could it be a water issue?
Finally, Hayward replaced the motor on the VSP 3 days ago and the tech, that was really good', did some program grouping for me. I also had an actuator valve that was installed incorrectly by the PB for the filter-bypass, so he corrected that. He grouped the filter bypass [valve-3], the heater and spa all together. I was going to run the spa, heater and blower together bc I do so to circulate water this way, and run the heater periodically for maintenance purposes. After putting in spa mode and starting the heater from the remote, I meant to hit the blower, but I hit the filter-bypass [valve-3] and when I re-hit the filter bypass to turn it off, it turned off both the spa and heater. Could this have had an impact.
As a follow-up, I just went out again to the c-panel and went from pool to spa mode, then turned on the heater again and after 15 sec's, it did not fire-up like it usually does in 3-4 seconds.
Is there anything I can do to troubleshoot this or does anyone have any recommendations?
thanks,
tstex