Hi,
On my Jandy Lite2 control panel the 'increase temp' button does not work.
I can reduce the temp, but not increase it, and all the other buttons seem to work.
Right now the set temp is 74 and I can't make it go higher.
I did just find that the manual states that all settings can be reset by holding the ENTER button for 7 secs. Default factory pool temp is 80 degrees. I will try this at lunchtime.
But... anybody know if the button can be fixed without replacing the controller?
Thanks,
ft.
--- TFP Supporter status submitted ---
On my Jandy Lite2 control panel the 'increase temp' button does not work.
I can reduce the temp, but not increase it, and all the other buttons seem to work.
Right now the set temp is 74 and I can't make it go higher.
I did just find that the manual states that all settings can be reset by holding the ENTER button for 7 secs. Default factory pool temp is 80 degrees. I will try this at lunchtime.
But... anybody know if the button can be fixed without replacing the controller?
Thanks,
ft.
--- TFP Supporter status submitted ---