Help with leaking pump

[justsayin]

After this thread Squealing Pump I decided to have the motor rebuilt after closing, installed but couldn't test.

Opened today and water is leaking at the seal plate, I didn't change anything just reconnected using what was there.

Sta-rite mpra6e 1 hp could someone tell me the parts I'd need to change to be able to run the pump.

There is a parts list here http://www.pentairpool.com/pdfs/DynaGlasDynaMaxPumpsOM.pdf

TIA

 

[Richard320]

It looks like parts 6, 7, and 10 need replacing when you pull it apart. You'll need some lube for the O-rings, and the directions mention liquid dish soap for the shaft seal #7.
Not exactly the same, but it should help you visualize things: Pentair Whisperflow seal replacement How-to (w/ photos) A little googling might turn up a video on youtube as well.

 

[justsayin]

Thanks very much Richard.

 

[justsayin]

I replaced the suggested parts now getting a drip from the bottom only when it's running. I tried to take a video but can't upload it here so took a screenshot from the video, I can't tell where it's leaking to know how to stop it.

Thanks for any help.

edit took it apart and rechecked my installs small mess up on my part all good to go now.