Hello,
I have an 8 year old pool with Hayward equipment including the Goldline Aqua Logic AQL-PS-8 automation system. I just had my second main board (GLX-PCB-MAIN) go out (the clock would not stay set; Goldline customer service said when the clock goes out the only option is to replace the board). The original board laste 5 years, this one just short of 3 years...don't get me started on what I think of the build quality.
After reading posts about how easy it is to do a DIY board replacement I bought a new one on Amazon and installed it today. It is indeed a simple task all around. However, I now have an issue with the wireless. The system is working fine from the main box control panel. When I try to use either the wireless remote display or the spa side remote, no signal is being received. The display on the wireless remote shows "the base receiver is not responding". However, if I bring the remotes next to the main box and open the door so the display is visible a connection is made. It is as if the wireless signal is very weak, or the antenna outside of the box no longer works. FWIW, I have gone back and verified all connections are correct and are well seated (no issues were found).
Any ideas? I figure I'll call Goldline on Monday for their thoughts before asking Amazon for an exchange. Any help will be appreciated.
Thanks in advance,
Barry
I have an 8 year old pool with Hayward equipment including the Goldline Aqua Logic AQL-PS-8 automation system. I just had my second main board (GLX-PCB-MAIN) go out (the clock would not stay set; Goldline customer service said when the clock goes out the only option is to replace the board). The original board laste 5 years, this one just short of 3 years...don't get me started on what I think of the build quality.
After reading posts about how easy it is to do a DIY board replacement I bought a new one on Amazon and installed it today. It is indeed a simple task all around. However, I now have an issue with the wireless. The system is working fine from the main box control panel. When I try to use either the wireless remote display or the spa side remote, no signal is being received. The display on the wireless remote shows "the base receiver is not responding". However, if I bring the remotes next to the main box and open the door so the display is visible a connection is made. It is as if the wireless signal is very weak, or the antenna outside of the box no longer works. FWIW, I have gone back and verified all connections are correct and are well seated (no issues were found).
Any ideas? I figure I'll call Goldline on Monday for their thoughts before asking Amazon for an exchange. Any help will be appreciated.
Thanks in advance,
Barry