Become a TFP Supporter Pool Math Forum Rules Pool School
Results 1 to 2 of 2

Thread: AQL-PS4 with a Hayward T-15 Salt Cell gets "Cell Power Error"

  1. Back To Top    #1

    Join Date
    Dec 2015
    Location
    Dickinson Texas
    Posts
    1

    AQL-PS4 with a Hayward T-15 Salt Cell gets "Cell Power Error"

    Afternoon all,

    I have a AQL-P-4-X295 with a T=cell-15. I keep getting a cell power error, also. I can get it to reset by shutting the breakers down and the cell runs correctly for anywhere from 5 minutes to 4 days before it shuts down with a error. The display on the AQL shows a salt level of 5700 ppm when it is tested at 2 different pool stores, the salt level is about 2900 ppm. I have checked the back of the board and there were brown spots on the back of resistors at T25 and T26. I replaced the resistors and checked the K1 connection and it was looking good. I resoldered the connections of K1 just to make sure and the salt level reading is still 5700 PPM.

    Does the AQL need to be told that there is a SWG inline and does it need to know the size? The Yahoo that installed that SWG for me has gone out of business or fled the jurisdiction. I had the Cell tested at Leslies Pool and it tested good.

    I hate to buy a board if it is a minor thing.....

  2. Back To Top    #2

    Re: AQL-PS4 with a Hayward T-15 Salt Cell gets "Cell Power Error"

    I would suspect that the cell size is not properly set in the configuration menu.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •