Hey all, so this AM hot tub was fine.. left and came home after about 4 hours and noticed 2/3 of the water gone and no power. What is perplexing is the water loss. Makes no sense to me. Tub is on an elevated deck and there is no sign for water loss underneath it. Even took of the panels and completely dry. Ideas?
Lost water and no power
- Thread starter jjdurrant
- Start date
Whoa! That is odd! Anyone playing tricks on you???
Where does your water go when you drain the tub? How do you normally remove water?
Where does your water go when you drain the tub? How do you normally remove water?
I did as I topped it off this AM! Didn't even think of that!!! LOL
So you think it siphoned so low something tripped on the board?
Once there was no flow it probably tripped the flow sensor. I left the hose once in my parents above ground. The hose had some leaks which caused it to siphon a bunch of water over a couple of days before I noticed.
Ok.. I would think I would still at least have power to the panel even with the sensor tripped right?
Ya, if you loss all power maybe something else is happening. Did you check the breaker at the house?
Yeah.. breaker is good. Going to try to replace the two larger fusetron fuses.. the smaller clear ones look fine. If that does not work will have to place a service call 
fuses tested good with multimeter.. at a loss.. waiting on service guy to show. Will keep you all updated.
Ended up being the heating element which got toasted with the loss of water.. $220 replaced.. not bad.. just irritating it was self inflicted