- Jun 3, 2008
- 42
I have been getting a Clean / Check Cell error on my system. Up till now the thing has run FLAWLESSLY since '08 - I LOVE my pool pilot!
+/- 20K gal in-ground. Water is always PERFECT. I admit to being a little lazy this year with checking and maintenance (23 days of measurable rain in June kept me out of the pool)
Read the manual and did the Acid soak. There was no white scale but when I rinsed it after the acid I was amazed at the amount of black, flaky junk that came out. There is no visible 'wear' on the corners of the plates.
It it currently running 28V @ 4.3A. The total Amp Hours is 32752 (that seems high) I run the system from 9A to 9P every day from Mid April - Mid Oct (central PA)
I haven't checked my actual salt with the TFT kit lately but will this weekend - the display reads 2800-3000. Funny thing is that sometimes the Error light is not on for hours and then it magically starts again.
Any suggestions? Should I just suck it up and buy a new cell?
Love this place! Thanks for any help
+/- 20K gal in-ground. Water is always PERFECT. I admit to being a little lazy this year with checking and maintenance (23 days of measurable rain in June kept me out of the pool)
Read the manual and did the Acid soak. There was no white scale but when I rinsed it after the acid I was amazed at the amount of black, flaky junk that came out. There is no visible 'wear' on the corners of the plates.
It it currently running 28V @ 4.3A. The total Amp Hours is 32752 (that seems high) I run the system from 9A to 9P every day from Mid April - Mid Oct (central PA)
I haven't checked my actual salt with the TFT kit lately but will this weekend - the display reads 2800-3000. Funny thing is that sometimes the Error light is not on for hours and then it magically starts again.
Any suggestions? Should I just suck it up and buy a new cell?
Love this place! Thanks for any help