Aquarite control box

[carl292]

Hey everyone I was cleaning the cell on the system and reset the flashing lite by holding it for a second and apparently I put the system in metric mode. I did it awhile back and you have to press the button once and slide the lever to off or super chlorinated then down. Something like that. Does anyone know please?

 

[pabeader]

Temperature Display
The Temperature Display shows the current temperature of the pool water. The factory default
display is in ºF. Both the Temperature Display and the Salt Display can be programmed to display
in Metric units. To display temperature in ºC and salt level in g/l, perform the following steps:
1. Slide the Main Switch to the "Auto" position.
2. Push the Diagnostic button repeatedly until "ºF" appears on the display.
3. Slide the Main Switch from "Auto" to "Super Chlorinate" and back to "Auto".
4. Push the Diagnostic button to exit.

To switch back just repeat the steps: Looking for ºC and change to ºF

 

[carl292]

So if I want to go to F, default. Then it's push button and slide from auto to super chlorinated back to auto.
That's kinda what I remember. Thanks again