Just installed a new SGS Breeze system, it is installed in pool return line above all pool equiptment (there is a bypass with a check valve after the cell that dumps back into spa side for spa spill over.
The unit is wired to the Pentair intelletouch control panel to the load side of the pump relay to only power on while pump is running.
The system appears to work great in pool mode. The problem is that when in spa mode (pump obviously is running so there is power to the unit) the salt cell still produces chlorine with no water flowing through the cell.
Would that point to a defective flow switch inside the cell?
The unit is wired to the Pentair intelletouch control panel to the load side of the pump relay to only power on while pump is running.
The system appears to work great in pool mode. The problem is that when in spa mode (pump obviously is running so there is power to the unit) the salt cell still produces chlorine with no water flowing through the cell.
Would that point to a defective flow switch inside the cell?