I purchased an Intelliflo VS 011018 pump to replace my AO Smith Conservationist. My hope is to reduce noise and energy costs.
I have a Jandy AqualinkRS6 Combo, Model 8157, firmware JJ.
I wired the Intelliflo just like the AO Smith.
I initially got no power to the Intelliflo LED and if I tried to bump the pump with the Aqualink panel I received an error message on the Intelliflo LED that says POWER OUT FAILURE.
I then wired the Intelliflo to the breaker and got the LED to power up and I was able to operate the pump using the Operator Control Panel. Unfortunately the pump that assists the Polaris 380 and the communication that talks to the SWG do not work if I wire this way.
I called Pentair and they told me to purchase an Intellicom II.
I called Jandy and they would not give electrical technical support since I identified myself as a homeowner.
Anyone out there have experience or advice on this matter?
It is much appreciated.
I have a Jandy AqualinkRS6 Combo, Model 8157, firmware JJ.
I wired the Intelliflo just like the AO Smith.
I initially got no power to the Intelliflo LED and if I tried to bump the pump with the Aqualink panel I received an error message on the Intelliflo LED that says POWER OUT FAILURE.
I then wired the Intelliflo to the breaker and got the LED to power up and I was able to operate the pump using the Operator Control Panel. Unfortunately the pump that assists the Polaris 380 and the communication that talks to the SWG do not work if I wire this way.
I called Pentair and they told me to purchase an Intellicom II.
I called Jandy and they would not give electrical technical support since I identified myself as a homeowner.
Anyone out there have experience or advice on this matter?
It is much appreciated.