I installed a replacement PC Board for my heater this afternoon. The instructions that came with it were great up to the very end where it says... " Connect the wire harnesses to the board".
There is a black and white photo taken at a 45 degree angle but it really doesn't show much ( I also found the same image in color on-line-still not much help). There are several connecters, some with three pins some with four, one with 12 or 16 (a bunch). There are more than 1 each of the 3 and 4 pin places to put each on the board. The board is quite different than the old one so that won't help, I'm not sure about the 'P' (P1, P2, P3, etc...) numbers being the same as the old board and the other markings aren't really helping either.
The board part number is 010253f. It is a retro fit for the original, it came with a new temp probe which I replaced.
Anybody else have this problem? I was guessing earlier at which places the connecters belonged, but I really don't want to plug it in and cross my fingers that I got it right.
Oh-yeah, I called Raypak a few days ago because I wanted to make sure I had the correct part number. The lady that answered told me to hold, a guy answered the phone and asked me for my dealer number. I told him I was a consumer/pool owner, he said he wouldn't talk with me, kind of coarsely (my pleasant way of describing him). I don't see much sense in calling there again.
My wife wants the water warmed up! (replaced the switch decal already too)
Help and thanks!
There is a black and white photo taken at a 45 degree angle but it really doesn't show much ( I also found the same image in color on-line-still not much help). There are several connecters, some with three pins some with four, one with 12 or 16 (a bunch). There are more than 1 each of the 3 and 4 pin places to put each on the board. The board is quite different than the old one so that won't help, I'm not sure about the 'P' (P1, P2, P3, etc...) numbers being the same as the old board and the other markings aren't really helping either.
The board part number is 010253f. It is a retro fit for the original, it came with a new temp probe which I replaced.
Anybody else have this problem? I was guessing earlier at which places the connecters belonged, but I really don't want to plug it in and cross my fingers that I got it right.
Oh-yeah, I called Raypak a few days ago because I wanted to make sure I had the correct part number. The lady that answered told me to hold, a guy answered the phone and asked me for my dealer number. I told him I was a consumer/pool owner, he said he wouldn't talk with me, kind of coarsely (my pleasant way of describing him). I don't see much sense in calling there again.
My wife wants the water warmed up! (replaced the switch decal already too)
Help and thanks!