Hello!
I'm new to this form so forgive me as I try to figure it out!
I have purchased three Intex metal frame above ground pools in the past four years (5,000 gallons). Each one has been fine for many months and then one day will begin rolling and within half an hour the seam connecting the wall and floor bursts. It always rolls the same direction. We had a concrete slab poured for the pool so it is on level ground. At first we thought it was because the kids were being too rough (cannon balls, waves, general kids pool behavior) but this time they were just floating/hanging out. It started to go a month ago so we drained the pool, re-positioned and had it refilled ($250!) but this evening it burst yet again. Has anyone had a similar experience? Any theories why this keeps happening? We had a large amount of rain recently, could it be connected? Is there a way to prevent it happening again in the future? Thank you!
I'm new to this form so forgive me as I try to figure it out!
I have purchased three Intex metal frame above ground pools in the past four years (5,000 gallons). Each one has been fine for many months and then one day will begin rolling and within half an hour the seam connecting the wall and floor bursts. It always rolls the same direction. We had a concrete slab poured for the pool so it is on level ground. At first we thought it was because the kids were being too rough (cannon balls, waves, general kids pool behavior) but this time they were just floating/hanging out. It started to go a month ago so we drained the pool, re-positioned and had it refilled ($250!) but this evening it burst yet again. Has anyone had a similar experience? Any theories why this keeps happening? We had a large amount of rain recently, could it be connected? Is there a way to prevent it happening again in the future? Thank you!