impeller

  1. DigitalDJ

    Impeller Issue: 1.5HP Hayward Self-priming Super Pump (C48L2N134B1)

    Hello everyone, We live in New Jersey. Pool was closed last winter and working fine at the time. Pool was opened yesterday and when we started the pump the impeller would not spin and the pump would overheat and click off. - Capacitor was tested and was not the problem. - Checked the impeller...
  2. A

    Impeller replacement issue

    Hi all. I’m replacing the impeller on my Waterway 1.5 hp pump. Two questions: 1. The shaft was fairly rusted where the impeller attaches. I sanded most of it off but not sure if I got enough of it off. How can I tell if the impeller is seated far enough? It is plenty tight. 2. I cannot get...
  3. B

    Pentair Intelliflo VS - off-balance impeller

    Hello All, My pump had seemingly been running fine for the past ~8 years but I turned it off to switch over for a backwash and when I switched the pump back on it showed an over current error that won't clear. Read through a few threads and found my impeller wouldn't budge. I took the pump...
  4. B

    Inspecting Pentair Superflo VS Internals

    While closing my pool last season, my relatively new Superflo VS (2 seasons = 10 months of use) started losing voltage/tripping it's breaker. It happened relatively quickly after running dry for a few minutes. I had never had any electrical problems with my setup before. The problem seemed to go...
  5. s9601694

    Jandy HP Plus impeller moving independently from driveshaft

    I noticed one of my Jandy HP Plus pumps wasn't pumping. Normally some sort of priming issue but there was water in the basket reservoir and there was no pressure in the pump. After taking it apart and inspecting it I found that the impeller is loose and moving independently from the shaft. It...
  6. B

    Impeller for Discontinued Jandy Estealth

    Hello all, I have a jandy 2hp estealth pump SMPH2.0 I need the impeller repair kit in a bad way. Out of stock everywhere and hints from some sites and local resources that this part is discontinued. Do I have any options other than replace the entire pump? the kit part no is r0445305 The...
  7. R

    Possible impeller problem

    My Hayward Super Pump (1 1/2 HP) began making a loud rattling noise very similar to cavitation (sounds like rocks in the impeller). It seemed to get worse and worse until finally I just couldn't run the pump because it was so loud. The water flow (circulation) was fine and I couldn't notice a...