|
It is currently May 25th, 2012, 3:53 pm
|
 |
|
 |
|
| Author |
Message |
|
sk8er72
|
Post subject: showing high temp sc60  Posted: September 6th, 2011, 9:57 pm |
Joined: May 24th, 2009, 9:51 pm
Posts: 5
|
|
Auto pilot just started showing a pool temp of over 100 degrees when in fact the water is about 80. I have turn the unit of and back on but still showing over 100. also it after turning off and on it show to add 300 lbs of salt but within about 5 minutes it show 3300 salt level. the unit is about 4 years old with about 4 months each year of use. Thanks
_________________
45000 vinyl IG - salt water Pool Pilot 60 - 24 by 48 - DE hayward - 2 hp pump
|
|
|
|
 |
|
Poolsean
|
Post subject: Re: showing high temp sc60 Posted: September 7th, 2011, 1:17 pm |
| Special Contributor |
 |
Joined: April 15th, 2007, 9:48 pm
Posts: 1203
Location: Ft Lauderdale, Florida
|
|
Sounds like a bad tri-sensor connection. Check to make sure it is not loose or that the connector pins have not been bent or damaged. Also, if you wiggle the connector and it corrects the temp reading, then the connector is too loose.
_________________
Sean Assam
Commercial Products Sales Manager
Aqua Cal Heat Pumps
AutoPilot Salt Chlorine Generators
www.autopilot.com
www.aquacal.com
sean@teamhorner.com
|
|
|
|
|
|
|
|
 |
|
 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
RSS Feed 
