Search results

I just used a jumper on pins 1 and 2 on the Autopilot, and the Low Flow error went away.

When doing the continuity test on the flow switch of the Autopilot Tri sensor, are you supposed to get perfect Continuity? I am getting resistance readings that are bouncing around. I am getting the Low Flow error even at 90 GPM. I also cleaned the screen, and the check valves are working as...

I have an Aquabot T4 Turbo remote, and previously had an Aquabat Turbo Plus. I tend to leave mime in the pool most of the time. I can get with the T4 six to eight hours between filter bag cleanings, so I just run the bot one to two hours every day or so to vacuum and I think more importantly...

I just wrapped duck tape around the end of mime until it was snug in the skimmer.

I agree with Jeff take off the cover, but also check the cord that goes from the control unit to the cell. I got a new control unit (under warranty) only to find out that the both the red and black plugs (they are just banana plugs, think stereo) that plug into the bottom of the control unit...

Check out http://www.e-zpatch.com the may have a helpful product.

Most of the time I just rinse my dirty filter bag in a bucket of pool water. I usually have to do 3-4 changes of water. Rich

Yes like anything with pool in its name cost! Also the solar salt has bigger junks, but that is not a problem; just takes a little longer to disolve.

I just pour the salt in the skimers (3) by the time I get the third filled the fist one has almost desolved. Since I need 1,200 lbs of salt I try to find the 80lb gags of solar salt in the blue bags. The last time, it cost about $7 per bag, however that store has closed, So I may need to go...