Search results

I have a 10-year old Minimax that will not start and has code E05. On the front panel, the Power, Pressure SW and Service lights are on. The Thermostat light is off. I removed and cleaned the ignitor. I do not smell gas, and there are no clicking sounds. Please advise. Thanks, Jim

Still looking for a solution

No, I do not have a surge protector, but all other home electronics was functioning at the time the motor quit.

I have a 2-year old Ecotech variable speed pool pump motor that just failed. The run/start button flashes green continuously and the other buttons and the display do not work. I tried a factory reset and power cycling, but that did nothing. The shaft turns freely when disconnected from the...

My Instant salt reading starts at 3600 and then rapidly declines to around 2400. Water temp is 72.

The salt readings on my Aquarite SWG vary from 600ppm to 3500ppm over 1-2 days. My actual salt level as tested is 3600ppm and has been consistent. My cell is 3 years old, but has been regularly maintained and is clean inside. All wires and connections have been checked and are good. I have...

Thanks Jason - that looks like the solution - I have one on order.

Thanks everyone for your assistance. My motor does have an RS485 connection, but it is not connected to anything - would that be the problem?

I recently replaced my main pump motor with an Ecotech EZ variable speed motor, and would like to know how I can operate this through my Jandy RS and PDA remote controller. At present, I must adjust the speed manually (from the controller on the motor) if I want to switch from pool to spa mode...