Search results

Search the forum Search WordPress Search MediaWiki
  1. C

    Jandy Aquapure Beep won't turn off

    Holding Salinity button for 5secs is supposed to disable the beep, but doesn't. The SWG hasn't worked for some time, I add chlorine. Anyone have tricks for disabling annoying tone... permanent is fine
  2. C

    Blue/black or Dark Blue cover

    My pool is on South side and I don't like the normal "med blue" color, because it reflects too much bright light.. My pebble tec is darker and I like the deep, dark blue color. If any of you have a blue/black cover, can you send a pic of the pool? I can't be the only one that doesn't like the...
  3. C

    Jandy LT400N Heater, no power

    I have no power to my heater (havent used in awhile). Where is the fuse located? Unfortunately, looks like mice made a nice condo... wil be tracing wires tks
  4. C

    Jandy Aquapure 3-port: cell hot at 100%-- normal?

    was running SWG at 100%, for a little "green" in water (ongoing problem, high cya, high calcium).. been dealing with deposits in SWG, which I seem to have eliminated by lowering PH to 7.3. Cleaning cell yesterday right after turning pump off... noticed cell and water inside is very hot... is...
  5. C

    Cdclw

    High CYA may be the root of my problems CYA at 99-- Jandy/zodiac SWA quit this winter, just replaced with new 3 port cell, doesn't seem to be producing any free chlorine.. but all tests show working proper... HELP Pool store (Leslie's) test: Salt 3000 CH: 550 (high) CYA: 99 Copper/Iron 0...
  6. C

    Jandy Aquapure 1400 (2port), High cell votage = bad cell?

    Ran all tests in Jandy T/S manual, Have error code 120/121 (low cell current) Cell voltage at 70 VDC, should be 22-28... does this indicate bad cell: I assume (basic electronics) low cell current is leading to the high voltage... cell is several years old... have cleaned, doesn't help best...
Top Bottom
Back