Search results

It seems impossible to find a lower runway, left turn, for an interfab wild ride slide. Anyone have a good source for parts like this ? I hope not to buy a new slide

Ok, here's the situation. My pool is losing water. It possibly started last summer late. A mid winter snow storm destroyed my mesh cover which is how I noticed the pool was danger low. I added some water and marked the level a few weeks ago. Seemed to be alright so I put a lot more water in; and...

I am replumbing my equipment pad. I would like to be able to isolate the heather and SWG. What is better, 3way valves or tees with a ball valve on each side.

My pool has been loosing some water and it's wet around me heater so I took it apart. Wowzers! Everything is wet! I think there is insulation between the burners that is like mud. Think I can replace just the heat exchanger?

Has anyone ever done that math to figure out if an industrial chlorine powder would work? Save all those jugs too.

So I open the pool this year and my 2HP super pump is leaking a good volume out the bottom. After losing a ton of water the pool is open, clean, and I am ready to take on the pump. I buy all new gaskets and replace them. To my surprise it doesn't fix the problem. I hold my breath and go in the...

My pool has been open for a few weeks with no problems. I noticed the pool was a bit cloudy and burning through more bleach than anticipated. At the point I have had 0 fc readings twice. I am headed to the store for some bleach and plan to add just after sunset, test in 30 min, then see what...

I just fired everything up from the winter because I noticed some stuff growing so I wanted to get the pool up fast. I believe I have a leaky gasket on the filter basket. I have suction and operating at normal pressure. Can I keep this running till I get to the store tomorrow or do I risk damage...

If I use ph- powder for the acid wash recommended here in a 10:1 mixture, how much do I add per gallon of water?

I let someone vacuum my pool the other day, and they pulled it out without disconnecting it from the skimmer first. I noticed rather quickly because I heard a strange noise from the pump.:mad: I proceeded to re-start the system as if it was the first time for the year. The weird thing is now...

I have had my pool open for a few weeks now and just turned the heater on. My pool heated up to 75, then I noticed the HS error light was on. My heater is only a year old, i have a call into the pool builder but haven't heard back. Does anyone know if this is a part that commonly goes bad (so I...

I just got my fas/dpd test today. I added CYA on monday. FC=1, CC=7.5, PH=7.4, TA=110, CH=90, CYA=30 Using the test from my K-2005 last weekend my cc=0 as it did all but once last year. could the high cc reading be false or is it because I am using a more accurate test kit? I plan to start SLAM...

I have virtually no CYA in the water; can't really test less than 30ppm. I use a tri-chlor feeder all season. Last year my pool builder told me to never add CYA because I use tri-chlor. By the time I closed the pool, I think i might have had 30ppm in the water, then I lowered the level for the...

Happy Spring everyone. I am getting a jump on opening the pool before it gets warm enough for anything to grow. I just tested my water which is probably about 1/3 from snow and rain; i have a mesh winter cover. FC=0, CC=0, PH=6, TA=20, CH=40. I used my test kit from last year, is that a...

I have a mesh cover, and it appears my pool is full again. It is hard to say because it could just be the ice on the cover pushing the water into the return. I was planning on opening in a couple weeks. Should I drain the pool a little so that if it rains, likely, the pool doesn't fill higher...